* Estimated delivery times start from the date of shipment, excluding processing time.
* Actual delivery times may vary due to holidays, weather conditions, or customs delays.
Tips:For questions about your order, place of delivery, product discount, taxation, delivery time, warranty, shipping, payment, exchange rate, and other questions unrelated to the product, please contact customer service.
showing 1-5 of 5|
Show Original
A part of the QA has been auto-translated.
0
Q:
what is the diameter of the thread that goes into the servo? I need to buy washers separately.
what is the diameter of the thread that goes into the servo? I need to buy washers separately.
The 1.3mm refers to the diameter of the hole where the control rod will go. You put the bolt sticking out of the bottom into a control horn on the control surface of your airplane. You then place the control rod into the hole that is 1.3mm in diameter. If your rod is bigger than 1.3mm, you need a larger control linkage stopper. Adjust the control rod for the neutral position of the control surface after you have centered your servo. Then you tighten the grub screw in the top so it doesn't move from that spot.
The 1.3mm refers to the diameter of the hole where the control rod will go. You put the bolt sticking out of the bottom into a control horn on the control surface of your airplane. You then place the control rod into the hole that is 1.3mm in diameter. If your rod is bigger than 1.3mm, you need a larger control linkage stopper. Adjust the control rod for the neutral position of the control surface after you have centered your servo. Then you tighten the grub screw in the top so it doesn't move from that spot.